Joined in 2023 
82 
63 About this deal
I was very limited on tools and time, but from what I remember I ended up using a nearby dumb switch, nuking the static IP on the Pi controller, rebooting it, and resetting the USG. (Keeping it completely on it's own network using the dumb switch.) I also made sure the USG was forgotten from the controller. NOTE: When editing this customjson file, it is not necessary to include everything. You must only include the complete "path" to the items you have edited, anything outside of the path can be omitted. as described below, even the USG Pro 4 is unable to make full use of a symmetrical gigabit Internet connection with both IPS and DPI enabled (even before enabling QOS). Hardware offloading lets you use dedicated hardware to accelerate some tasks. You can turn it on or off depending on what you are trying to do. This applies to the USG/USG-Pro, and also EdgeRouters. With the USG Pro 4, our WAN throughput with both IPS and DPI enabled is 479 Mbps up and 647 Mbps down, as reflected on the USG Pro 4’s new speed test. Recommended Configuration
The DNAT rule # ranges are from 1-4999, and the Source/Masquerade rule numbers are from 5000-9999. If you wanted to add a port forward (DNAT) in the config.gateway.json for WAN2 in a multiWAN (load-balance) setup, this is what the config.gateway.json would look like with only this particular NAT rule: One potential problem with the UXG-Pro is the current state of the UDM-Pro and UniFi OS. Some features on the UDM-Pro are not working, incomplete, buggy, or just missing. Development for the Dream Machines has been steady, but after 9 months, the UXG is still on on beta firmware version 0.5.0.
Dream Machine
So, many people have asked what is the benefit of using a UXG-Pro, we’ll be covering that in a separate ‘vs’ article, but in this one we are comparing the brand new UXG-Pro and the previous USG-Pro-4. The USG-PRO-4 WAN port, as a result of being a combination SFP/GigE port, is a pure 1 Gbps port – it is incapable of both 10 Mbps and 100 Mbps FDX/HDX settings. Redesigned to be more intuitive and easier to navigate, the new UI raises the bar for enterprise network management efficiency. Important network details are logically organized for a simplified, yet powerful, interface. Resets to factory defaults. The UniFi Gateway should be running after bootup is complete. Press and hold the Reset button for about 10 seconds until the right LED on the WAN2 port starts flashing and then becomes solidly lit. After a few seconds, the LED will turn off, and the UniFi Gateway will automatically reboot.
we complemented our aggregator Unifi Switch 24 with a 16 POE-150W switch so that we can support current and future PoE devices like the Cloud Key Gen 2, Ubiquiti Unifi WiFi APs, and Ubiquiti Unifi Protect video cameras
Economical specification - rich in features
we replaced five legacy passive switches in our network with six 8 POE-60W actively managed switches, and
Great Deal 
New Comment